Programming instructions

10
Programming Functions (cont'd)
The DL1200 is capable of emitting 1 of 4 possible keypress sounds:
• High Frequency Keypad Feedback + Led
• Low Frequency Keypad Feedback + Led
• "Click!" Keypad Feedback + Led
• Led Only
[ __ __ __ __ __ ] ; 220 ;
Master Code**
High Freq KP Keypress Sound + Led
(Default)
Keypress Sound Options
[ __ __ __ __ __ ] ; 221 ;
Master Code**
Low Freq KP Keypress Sound + Led
[ __ __ __ __ __ ] ; 222 ;
Master Code**
Click! KP Keypress Sound + Led
[ __ __ __ __ __ ] ; 223 ;
Master Code**
Led Only
Disable/Enable Users in Bank
Enter Bank number (0-9) to Enable/Disable all Users in Bank. Entering a disabled Code will result in an
accented five beep error tone (indicating the User Access Code is valid but disabled).
Disable Users in Bank
[ __ __ __ __ __ ] ; 8 5 [ __ ] ;
Master/Manager Code** Bank Number
[ __ __ __ __ __ ] ; 8 4 [ __ ] ;
Master/Manager Code** Bank Number
Enable Users in Bank
When a key is pressed, a beep will sound and a Red LED will flash. Other indications are:
▪ Access Granted: 1 beep and a Green LED flash. (When Pass Time ends, the DL1200 locks with a beep and a
Red LED flash).
▪ Invalid Code Entered: 5 beeps and 5 Red LED flashes.
▪ Disabled Code Entered: 5 beeps (with extended first beep) and 5 Red LED flashes.
▪ New Access Code Accepted: 6 beeps and 6 Red LED flashes.
▪ Programming Error: 2 sets of 5 beeps and 5 Red LED flashes.
▪ Return from Anti Tamper Lockout: 2 beeps with a Red LED flash.
▪ Low Battery: High/Low sounder with flashing Red LED for 5 seconds. (See below to replace batteries).
Note: Keypress tones may be disabled using the ; 2 2 3 ; command (see Keypress Sound
Options, page 10).
Audible and LED Indications
** Required only if DL1200 is locked.