Programming instructions

9
[ __ __ __ __ __ ] ; 301 ; [ __ __ __ __ __ ]
Master/Manager Code** New Service Code
Service Codes are one-time-only Codes; once entered into the keypad, it is deleted. Use the same Code up
to 3 times by programming all three Service Codes with the same Code. Note: Service Codes are lost if
power is removed. To delete a single Service Code, press
;, enter Service Code number (301, 302 or
303), then press
; :.
Add/Delete Service Codes
Service Code 1
Service Code 2
Service Code 3
[ __ __ __ __ __ ] ; 302 ; [ __ __ __ __ __ ]
Master/Manager Code** New Service Code
[ __ __ __ __ __ ] ; 303 ; [ __ __ __ __ __ ]
Master/Manager Code** New Service Code
Delete All Service Codes
[ __ __ __ __ __ ] ; 300 ;
Master/Manager Code**
The Pass Time is the time the lock stays unlocked after a valid Code entry. Use the function below to change
the Pass Time from 02 to 20 seconds. The Pass Time factory default is 5 seconds. NOTE: The Pass Time
will also determine the amount of time allowed between keypresses during programming.
Pass Time ("Door Unlock")
[ __ __ __ __ __ ] ; 4 [ __ __ ] ;
Master Code** Pass Time
Pass Time
Allows passage without the need to enter a Code into the keypad.
Enable/Disable Passage Mode
Disable Passage Mode
[ __ __ __ __ __ ] ; 5 ; ("Normal Operation")
Master or Manager Code**
Enable Passage Mode
[ __ __ __ __ __ ] ; 4 ; ("Unlocked")
Master or Manager Code**
Programming Functions (cont'd)
Disable/Enable Groups
Disable Groups: All Managers can program all User Access Codes, regardless of Bank.
Enable Groups: (Factory default) Managers restricted to controlling only those User Access Codes within
their own Bank (column), and all following Banks until another Manager appears. User Access Codes in
Banks outside of that Manager's Bank cannot be programmed.
Enable Groups
[ __ __ __ __ __ ] ; 210 ;
Master Code**
[ __ __ __ __ __ ] ; 211 ;
Master Code**
Disable Groups
** Required only if DL1200 is locked.