Specifications

Keri Systems, Inc. Doors

Users Guide

01914-002 Rev. 5.5 Section 2: Setup System 2-39

5.0 Get Controller Status

The Controller Status tab allows an operator to verify that all controllers/doors are recognized and to

verify that the configuration information reported by the controller is correct.

5.1 Controller Status Fields

The following list shows the fields contained in the controller status spreadsheet with a short description

of the information it gives.

Door Name

A descriptive text name for the door (this field should be blank for a new installation as the door name

is assigned later in the database programming process – see “Assign a Door Name” on page 26 in

section 3).

Address

The address of each controller recognized by the network and each door recognized by the controllers.

There should be a line item in the spreadsheet for every controller/door in the access control network.

The addresses listed should match the addresses programmed into each controller on the access control

network.

Online

Indicates if the controller is ONLINE (the host computer is able to communicate with the controller) or

OFFLINE (the host computer is not able to communicate with the controller).

Cltr Type

• If the field displays a PXL-250, this indicates the controller is a PXL-250 without a satellite board,

and is capable of single-door control.

• If the field displays a PXL-500, this indicates the controller is a PXL-500 without a satellite board,

and is capable of single-door control.

• If the field displays a PXL-510, this indicates the controller is a PXL-510 without a satellite board,

and is capable of single-door control and alarm control.

• If the field displays an SB-293D, this indicates the controller is a PXL-250 with a satellite board

that is configured to support two-door control, and has 6 inputs and 2 outputs.

• If the field displays an SB-593D, this indicates the controller is a PXL-500 or PXL-510 with a

satellite board that is configured to support two-door control, and has 6 inputs and 2 outputs.

• If the field displays an SB-293X, this indicates the controller is a PXL-250 with a satellite board

that is configured to support 8 inputs and 4 outputs (and does not

control a second door).

• If the field displays an SB-593X, this indicates the controller is a PXL-500 or a PXL-510 with a

satellite board that is configured to support 8 inputs and 4 outputs (and does not

control a second

door).

• If the field displays an EGGoldV, this indicates the controller is an EntraGuard Gold and is capable

of single-door telephone entry control.

NOTE: When the letter S appears as the end of the display for a PXL-250 (i.e. PXL-250S), it refers to a

surface mount controller.

ROM Rev

Displays the revision of the firmware EPROM on the controller.