Specifications

Keri Systems, Inc. Doors
TM
Users Guide
01914-002 Rev. 5.5 Section 2: Setup System 2-33
Figure 2-38: Autoconfiguration in Progress
2.1 Successful Autoconfiguration
1. The Doors software will automatically determine whether you have a satellite board connected to
any of the controllers in the access network. For the controllers to which you do not have a satellite
board connected, you will be prompted to select whether you want to name and configure a second
reader for each controller (see Figure 2-39).
Figure 2-39: Setup of Multiple Readers
2. If you have connected two readers to this controller and you want to name and configure the second
reader, click on the button. If you have a large number of controllers and you want to
name and configure a second reader on all of them, click on the button.
3. If you have connected only one reader to this controller, or do not want to name and configure the
second reader, click on the button. If you have a large number of controllers and you
do not want to name and configure a second reader on any of them, click on the
button.
4. When all data is received by the host computer, the Setup System/Controllers window displays the
configuration information for all responding controllers on the access control network (see Figure
2-40 on page 34 of this section).