Specifications

Doors

Users Guide Keri Systems, Inc.

2-24 Section 2: Setup System 01914-002 Rev. 5.5

1.2.14 Set Alarm Control

See “Alarm Control” on page 1 in section 12 for a complete description of how to enable, use, and

disable the Alarm Control feature in Doors.

The Alarm Control parameter allows an operator to enable the alarm control feature of the Doors

program for use with a NetworX NX-8E Alarm Panel.

NOTE: In order for the Alarm Control feature to be enabled, a PXL-510 controller must be set as the

master controller and connected to a NetworX NX-8E Alarm Panel. For further information on

installing necessary controllers for use with the alarm control feature, refer to the PXL-500/PXL-510

Quick Start Guide (P/N 01918-001) and the NetworX NX-8E Alarm Panel Application Note (P/N

01919-001).

The program default is for Alarm Control to be OFF.

1. From the System Options tab, click on the button. The System Options

window will reveal the Alarm Control field (see Figure 2-28).

Figure 2-28: Alarm Control Field

2. If your system is not using a PXL-510 master controller connected to a NetworX NX-8E Alarm

Panel, Doors will not allow the Alarm Control feature to be enabled.

3. To enable use of the Alarm Control feature in connection with a PXL-510 master controller, click

in the check box beside the Alarm Control ON field. When there is a check in the box, the feature is

enabled. To disable this field, click in the check box again and remove the check mark (this is the

default value).

NOTE: A few changes are made to the access control databases when the Alarm Control feature is

enabled. These changes add the fields necessary to manage the alarm system. For simplicity in

explaining the features in the Doors program, the majority of this Users Guide assumes that the Alarm

Control feature is not enabled. Alarm Control related features are explained in detail in “Alarm

Control” on page 1 in section 12.