Specifications

Doors

Users Guide Keri Systems, Inc.

2-22 Section 2: Setup System 01914-002 Rev. 5.5

1.2.12 Set Card+PIN (P-650) Mode

NOTE: The Card+PIN (P-650) feature must be used in connection with the P-650 Card+PIN Proximity

Reader and Keypad, PXL-250W controller, and 26-bit Wiegand access cards to provide a secondary

method of user identification tied to the card itself. Enrollment of cards must be done by block

enrollment (see “Block Enrollment by Card Number Range” on page 3 in section 4). If a card is lost, it

should be voided from the system immediately.

The Card+PIN (P-650) parameter allows an operator to view the PIN associated with each access card.

The Card PIN (Personal Identification Number) is a special number automatically generated and

assigned to a card during enrollment when the P-650 is in use. This PIN allows a secondary verification

of a user by requiring a PIN be entered after presenting a valid access card. The Card PIN cannot be

changed or edited and must be given to the user with the card.

The program default is for Card+PIN (P-650) to be OFF. In order to view the Card+PIN (P-650) column

in the Setup Users window, the Card+PIN (P-650) feature must be enabled in the software.

1. From the System Options tab, click on the button. The System Options

window will reveal the Card+PIN (P-650) field (see Figure 2-25).

Figure 2-25: Card + PIN (P-650) Field

2. If your system is not using a P-650 Card+PIN Proximity Reader and Keypad, verify there is not a

check mark in the Card+PIN (P-650) ON box. This is the default value (see Figure 2-25).

NOTE: The system will automatically generate a card PIN number for each card during enrollment.

The Card+PIN (P-650) feature is only supported for the 26-bit Wiegand formatted card. PINs displayed

for other card formats are not valid PIN numbers and will not work on the P-650 reader.

3. To enable the Card+PIN (P-650) feature, click in the check box beside the Card+PIN (P-650) ON

field. A check mark appears in the check box and the following window appears (see Figure 2-

26 on page 23 of this section). When there is a check in the box, the feature is enabled and you will

be able to view the individual card PINs associated with each card in the User Spreadsheet window.