Specifications

Doors
TM
Users Guide Keri Systems, Inc.
2-20 Section 2: Setup System 01914-002 Rev. 5.5
1.2.10 Set Rollcall/Track
The rollcall/track parameter allows an operator to enable the rollcall/track control feature of the Doors
program. When the rollcall/track feature is enabled, the operator is able to view user status after
collecting events or during real time Montoring.
The program default is for rollcall/track to be OFF. To implement rollcall/track, the rollcall/track feature
must be enabled in the software and then activated for the desired cards/users.
1. From the System Options tab, click on the button. The System Options
window will reveal the Rollcall/Track field where the Rollcall/Track feature may be enabled (see
Figure 2-22).
Figure 2-22: Rollcall/Track Field
2. If your application does not use rollcall/track, verify there is not a check mark in the Rollcall/Track
ON box. This is the default value (see Figure 2-22).
3. To enable rollcall/track, click in the check box beside the Rollcall/Track ON field. A check mark
appears in the check box and the following window appears (see Figure 2-23).
Figure 2-23: Rollcall/Track Option Changed Warning - ON
4. Click on the button. A “Saved Configuration” window flashes on the screen.
5. Click on the button to save these changes. If the Rollcall/Track changes are not saved
before clicking any other button or exiting the System Options window, the data entered is lost and
must be re-entered.