Specifications

Keri Systems, Inc. Doors
TM
Users Guide
01914-002 Rev. 5.5 Section 2: Setup System 2-17
1.2.7 Set Door Type
The door type parameter allows an operator to enable the elevator, gate, and time and attendance
terminal control features of the Doors program. When the elevator, gate, or time and attendance
terminal control features are enabled, the Doors program makes several minor changes to support the
selections.
• A Door Type column is added to the System ⇒ Setup Doors tab allowing a specific door to be
identified as a door, elevator, gate, or time and attendance terminal (see “Assign a Door Type” on
page 29 in section 3).
• The standard icon for doors, viewed as , changes to appear as for doors identified as an
elevator, for doors identified as a gate, or for doors identified as a time and
attendance terminal when creating Access Groups (see “Setup Access Groups” on page 44 in
section 3) or when performing manual door control (see “Lock, Unlock, Suspend and Restore
Doors” on page 3 in section 6).
• An event filtering column appears in the Setup ⇒ Monitor and Events ⇒ Messages window when
elevator control is enabled (see “Elevator Reports Events” on page 23 in section 5).
1. From the System Options tab, click on the button. The System Options
window will reveal the Door Type field where selections may be made for door type control (see
Figure 2-15).
Figure 2-15: Door Type Field
2. If your application does not use elevator, gate, or time and attendance terminal control, verify there
are no check marks in the Elevator ON, Gate ON, or Time and Attendance Terminal ON boxes.
This is the default value (see Figure 2-15).