Specifications

Keri Systems, Inc. Doors

Users Guide

01914-002 Rev. 5.5 Section 2: Setup System 2-11

1.2.4.2 Global Unlock Enable

The global unlock enable feature allows the general purpose input of the master controller to be used to

automatically unlock all online and functioning doors in the access control network (refer to the PXL-

250 Tiger Controller and SB-293 Technical Reference Manual - P/N 01836-004, the PXL-250 Quick

Start Guide - P/N 01835-002, or the PXL-500 Quick Start Guide - P/N 01918-001 for general purpose

information).

1. To enable the global unlock enable feature click in the check box beside the Global Unlock Enable

field. When there is a check in the box, the feature is enabled.

2. To disable this field, click in the check box again and remove the check mark (this is the default

value).

NOTE: The global unlock enable feature is not fire marshall approved. Check your local codes for

fire safety management.

NOTE: Global Unlock takes precendence over ALL other lock or unlock commands. Any attempt to

Restore an Auto Unlock/Lock time zone while the Global Unlock is active will be ignored by the master

controller.

NOTE: Global unlock enable is disabled on the master controller if the master controller uses the

Auxiliary Request to Exit feature.

1.2.4.3 Global Lock Enable

The global lock enable feature allows the general purpose input of the master controller to be used to

automatically lock all online and functioning doors in the access control network. Global Lock

specifically uses Input 4 on an SB-593 Satellite board attached to the master controller.

1. To enable the global lock enable feature click in the check box beside the Global Lock Enable field.

When there is a check in the box, the feature is enabled.

2. To disable this field, click in the check box again and remove the check mark (this is the default

value).

NOTE: The global lock enable feature is not fire marshall approved. Check your local codes for fire

safety management.

NOTE: Global Lock takes precendence over ALL other lock or unlock commands EXCEPT for Global

Unlock. Any attempt to Restore an Auto Unlock/Lock time zone while the Global Lock is active will be

ignored by the master controller.

NOTE: Global lock enable is disabled on the master controller if the master controller uses the

Auxiliary Request to Exit feature.