Specifications

Keri Systems, Inc. Doors
TM
Users Guide
01914-002 Rev. 5.5 Section 2: Setup System 2-9
1.2.3 Set EntraGuard
See “EntraGuard” on page 1 in section 10 for a complete description of how to enable, use, and
disable the EntraGuard feature in Doors.
The EntraGuard parameter allows an operator to enable the telephone entry feature of the Doors
program for use with an EntraGuard Telephone Entry controller.
The program default is for EntraGuard to be OFF.
1. From the System Options tab, click on the button. The System Options
window will reveal the EntraGuard field where options concerning use of an EntraGuard controller
may be set (see Figure 2-6).
Figure 2-6: EntraGuard Entry Field
2. If your system is not using an EntraGuard controller, verify there is not a check mark in the
EntraGuard ON box (see Figure 2-6).
3. To enable use of an EntraGuard controller, click in the check box beside the EntraGuard ON field
1
.
When there is a check in the box, the feature is enabled. To disable this field, click in the check box
again and remove the check mark (this is the default value).
NOTE: Before disabling the EntraGuard feature, make sure there is no check in the Remote Commands
ON check box and there are no EntraGuard units connected to the network.
NOTE: A number of changes are made to the access control databases when EntraGuard mode is
enabled. These changes add the fields necessary to manage an EntraGuard controller. For simplicity in
explaining the features in the Doors program, the majority of this Users Guide assumes that
EntraGuard entry mode is not enabled. EntraGuard related features are explained in detail in
“EntraGuard” on page 1 in section 10.
1. The EntraGuard feature is automatically enabled if an EntraGuard unit is detected when an
autoconfiguration is performed on the system.