Specifications

Doors
TM
Users Guide Keri Systems, Inc.
2-8 Section 2: Setup System 01914-002 Rev. 5.5
1.2.1 Set Sites
See “Multiple Sites” on page 1 in section 8 for a complete description of how to enable, use, and
disable the multiple sites feature in Doors.
The Sites parameter allows an operator to enable or disable the multiple sites feature of the Doors
program.
The program default is for Sites to be OFF.
1. If the Sites ON field is not already visible on the System Options tab, click on the
button. The System Options window will reveal the field for enabling
multiple sites (see Figure 2-5 on page 7 of this section).
2. If your application does not use multiple sites, verify there is not a check mark in the Sites ON box.
3. To enable multiple sites mode, click in the check box beside the Sites ON field. When there is a
check in the box, the feature is enabled. To disable this field, click in the check box again and
remove the check mark (this is the default value).
NOTE: A number of changes are made to the access control databases when multiple sites mode is
enabled. These changes add the fields necessary to manage multiple sites. For simplicity in explaining
the features in the Doors program, the majority of this Users Guide assumes that multiple sites mode is
not enabled. Multiple site features are explained in “Multiple Sites” on page 1 in section 8.
1.2.2 Set Badging
For information regarding badging, please refer to “Photo Badge Management” on page 1 in
section 9.
Badging is a separate feature of the Doors access control software. Badging is not fully active until a
License Code is obtained from the Keri Systems’ Customer Support department. To support the
software used for badging, a fee is charged for this License Code. A demonstration version can be
installed if desired. Before installation, please refer to the badging requirements found in “Photo Badge
Management Requirements” on page 6 in section 1 to ensure your host computer is capable of running
the badging feature.