Specifications

Doors

Users Guide Keri Systems, Inc.

2-6 Section 2: Setup System 01914-002 Rev. 5.5

3. Click in the “Server’s Ethernet Port Number” field to enter the number assigned to the computer

running Doors. The default is set at 10021, but will need to be changed if it conflicts with another

device on the computer. Please consult with your network administrator before making any

changes.

4. Click in the “Remote Site TCP/IP Address” field and enter the address of the LAN-100 unit. The

address must be entered in the standard “dot” notation (e.g. 0.0.0.0).

5. If the site should be assigned a Personal Identification Number (PIN), click on the “PIN Number”

field and enter the PIN to be used for the remote site. This is an optional field.

NOTE: Once a PIN has been assigned to a site, an operator must know that site’s PIN to be able to

access that site. This is an extra security measure to ensure that an operator has authorization to access

any given site. When a PIN has been assigned to a site, it is stored in the software and is visible each

time you open the Network Config tab.

6. The Remote Site Port Number default is set at 0. This number will vary depending on whether a

LAN-50 or LAN-100 is being used. Consult your systems or network administrator before

changing this number.

7. Click on the button to save these changes. If the Ethernet TCP/IP parameters are not saved

before clicking any other button or exiting the System Setup window, the data entered is lost and

must be re-entered.