Specifications

Keri Systems, Inc. Doors

Users Guide

01914-002 Rev. 5.5 Section 2: Setup System 2-5

NOTE: Once a PIN has been assigned to a site, an operator must know that site’s PIN to be able to

access that site. This is an extra security measure to ensure that an operator has authorization to access

any given site. When a PIN has been assigned to a site, it is stored in the software and is visible each

time you open the Network Config tab.

5. In most cases the modem’s default initialization string (which is programmed into the modem)

meets the needs of the Doors program and no information needs to be entered into this field. If the

modem requires a special modem initialization string, click on the “Modem Init String” field and

enter the modem initialization string for the PC’s modem. As the modem initialization string differs

per modem type and manufacturer, refer to the modem’s manual for the initialization string.

6. Click on the “Remote Site Phone Number” field and enter the phone number for the modem

attached to the master controller at the remote site.

7. Click on the button to save these changes. If the COM port and modem parameters are not

saved before clicking any other button or exiting the system setup window, the data entered is lost

and must be re-entered.

1.1.2 Ethernet TCP/IP Parameters

If you are using a LAN (either LAN-50, LAN-100, or LAN-500) Ethernet Converter to communicate

between the host computer and the access control network, you must first install the LAN on the

network. See the LAN-50 Ethernet Communication Application Note

(P/N 01881-003), the LAN-100

Ethernet Communication Application Note (P/N 01881-001), or the LAN-500 Ethernet Communication

Application Note (P/N 01922-001) for information on how to install the LAN. Once you have the LAN

installed, you must configure Doors.

NOTE: A system or network administrator will be required to provide some of the necessary

information for setup of the LAN.

1. From the Setup System window, click on the Network Config tab. The Network Configuration

window appears (see Figure 2-3 on page 4 of this section).

2. Click on the TCP/IP radio button. The Network Configuration window will add new fields for

configuring the LAN-100 (see Figure 2-4).

Figure 2-4: Network Configuration Tab With TCP/IP Selected