Specifications

Doors
TM
Users Guide Keri Systems, Inc.
2-4 Section 2: Setup System 01914-002 Rev. 5.5
1.1 Set the Network Configuration Parameters
The following network configuration parameters need to be set for proper communication between host
computer and access control network.
Either
• COM port, including modem parameters
Or
• Ethernet TCP/IP
NOTE: For information regarding configuration parameters of a system that uses an EntraGuard
controller, please refer to “EntraGuard” on page 1 in section 10.
1.1.1 Set the COM Port and Modem Parameters
If the system is using the computer’s COM port for communication with the access control network,
either through direct connect or through a modem, perform the following steps.
1. From the Setup System window, click on the Network Config tab. The Network Configuration
window appears (see Figure 2-3).
Figure 2-3: Network Configuration Tab
2. Click on the COM port radio button (1, 2, 3, or 4) corresponding to the computer’s COM port that
will be used for communication between the host computer and the access control network. This
will be either the COM port to which a direct serial connection or external modem is connected, or
the COM port to which an internal modem is installed. Figure 2-3 shows COM port 2 enabled.
If the connection between access control network and host computer is made directly, skip to step 7.
However, if the connection is made through a modem, modem parameters must be entered.
3. Click in the “PC Phone Number” field (see Figure 2-3), and enter the phone number for the modem
attached to the host computer.
4. If the site should be assigned a Personal Identification Number (PIN), click on the “PIN Number”
field and enter the PIN to be used for the remote site. This is an optional field.