Specifications

Doors
TM
Users Guide Keri Systems, Inc.
15-8 Section 15: Video 01914-015 Rev. 5.9
2.2 Door Cameras Tab
Once the Video Server is set up, Cameras need to be assigned to specific physical doors. To assign door
cameras, from the Setup ⇒ Video window, click on the Door Cameras Tab. The Door Cameras window
appears (see Figure 15-9).
NOTE: Before beginning this section, assign camera names on the video server first. Once a camera
has been assigned a name and assigned to specific doors, changing the camera name will require a new
camer/door mapping.
Figure 15-9: Door Cameras Tab
1. Click on the button. A new blank row appears.
Door Address and Door Name
From the pull-down list, select the physical door to be assigned a camera.
Video Server TCP/IP Address
The TCP/IP address of the video server is automatically entered.
Video Server Name
The Video Server Name that was entered during the Setup Video Server process appears here.
Camera Name
From the pull-down list, select the camera to be assigned to the door in the first column.
NOTE: More than one camera may be assigned to each door and more than one door may be assigned
to each camera. It is all dependent on where the cameras are pointed.
2. Click on the button to save each row. Repeat the process for as many cameras/door
combinations there are. If the information is not saved before clicking any other button or exiting
the Setup Video window, the data entered is lost and must be re-entered.
• To make changes to a row that has already been saved, click on the row that needs changed and
then click on the button. Make the necessary changes and click on the button.
• To remove a row before it has been saved, click on the row to be removed and then click on the
button.
• To remove a row after it has been saved, click on the row to be removed and then click on the
button.