Specifications

Keri Systems, Inc. Doors

Users Guide

01914-014 Rev. 5.5 Section 14: Dual Verification 14-11

3. In the “Channels” field, select the reader or keypad channel to be used for enrollment. There are

three options available; “A” reader, “B” reader, or both readers used alternately. For this example it

is assumed that the “A” reader is a Wiegand card reader (and will be used as the Primary ID), and

the “B” reader is a keypad (and will be used as the Secondary ID). See Figure 14-15.

Figure 14-15: Enroll Cards - Channels Field

4. In the “Numbers” field, click on the Enroll Both radio button (see Figure 14-16).

Figure 14-16: Enroll Cards - Numbers Field

5. In the “Primary Format” field, click on the radio button that corresponds to the format of the

Primary ID (see Figure 14-17).

Figure 14-17: Enroll Cards - Primary Format Field

6. Once the Enroll Both radio button has been selected in the “Numbers” field, the “Secondary

Format” field becomes active. In the “Secondary Format” field, click on the radio button that

corresponds to the format of the Secondary ID (see Figure 14-18).

Figure 14-18: Enroll Cards - Secondary Format

7. Click on the button. If the Doors program is not connected to the access control

network, the program will automatically connect.

8. The primary reader’s LED blinks green slowly to indicate it is ready for enrolling cards.

NOTE: The reader/controller is not available for any other use during the card enrollment process –

any attempts to use a door associated with the master controller might disrupt the card enrollment

process and will be denied until card enrollment is complete.

9. Present the first card to the enrollment reader. The reader will beep to indicate the card was read

successfully and the card information will appear in the Enroll Cards window.