Specifications

Doors
TM
Users Guide Keri Systems, Inc.
14-6 Section 14: Dual Verification 01914-014 Rev. 5.5
4.0 Setup Users
Each person to be granted access to secured areas using the Dual Verification feature will need two
credentials assigned to them. For the following enrollment examples, it is assumed the Primary ID will
be a 26-bit Wiegand access card and the Secondary ID will be a PIN used on an Essex Keypad.
Through the Setup Users menu, an operator can enroll, void, and delete cards and PINs; assign cards
and PINs to users; enter and edit user information, including personal data fields; and apply access
groups to users. Once cards and PINs are enrolled, operators may use either the dialog box method or
spreadsheet method for entering user data. The dialog box method (“User Data – Dialog Box Method”
on page 13 in section 4) allows an operator to enter all user data through a series of “fill-in-the-blank”
type windows. The spreadsheet method (see “User Data – Spreadsheet Method” on page 22 in
section 4) allows an operator to enter all user data into a spreadsheet.
The following sections will instruct you on how to enroll users depending on the kind of system
installed. Take a minute and determine what kind of access control system is in use.
• Primary ID and Secondary ID - a new system
• Adding a Secondary ID to existing Primary ID system - when users have already been enrolled and
a Dual Verification controller is being added to the system
4.1 Enrollment of Primary and Secondary IDs
If this is a new system (with no users enrolled) and a Dual Verification controller is on the system, each
user will need to be assigned a Primary ID and a Secondary ID. They may be done at the same time or
separately.
The following instructions are based on the assumption that the Primary ID will be an access card and
the Secondary ID will be a Personal Identification Number (PIN) used with a keypad and that the
enrollment of these credentials will take place at the same time.
4.1.1 Enrollment of Primary and Secondary IDs by Block Number Range
1. To enroll Primary and Secondary IDs by block number range, click on the Setup ⇒ Users pull-
down menu or click on the tool bar button. These two icons are added to the tool
bar and the Setup Users spreadsheet window appears (see Figure 14-4). If the setup users
spreadsheet window is not visible, click on the tool bar button.
Figure 14-4: Setup Users Spreadsheet Window