Specifications

Keri Systems, Inc. Doors

Users Guide

01914-013 Rev. 5.3 Section 13: Temp Users 13-3

1.0 Enable Temp Users

The Temp Users ON check box is used to enable the temp users feature (see Figure 13-1). The temp

users feature allows an operator to set activation and expiration dates for the future. Once that pre-

assigned date and time is reached, the controllers will either allow entry (if a pre-set activation date and

time was set) or deny entry (if a pre-set expiration date and time has been set).

NOTE: The temp users feature only works with PXL-500 controllers. If you have a network with both

PXL-500s and PXL-250s, the doors controlled by the PXL-250 will not recognize a pre-set activation

or expiration date and will allow or deny entrance based only on whether the card has been turned

on.

1. To enable the temp users feature, click on the Setup ⇒ System pull-down menu or click on the

button on the tool bar, then click on the System Options tab.

2. Click on the button. The System Options window will reveal the field for

enabling temp users (see Figure 13-1).

NOTE: When the temp users feature is enabled, the user capacity drops from 65,535 possible users to

19,110 possible users.

Figure 13-1: System Options Tab - Temp Users Disabled

3. Click on the Temp Users ON box. A check mark appears in the box. Because the changes required

to implement the temp users feature make major changes to the Doors program and its supporting

databases, a confirmation window appears (see Figure 13-2 on page 4 of this section).