Specifications

Keri Systems, Inc. Doors
TM
Users Guide
01914-012 Rev. 5.5 Section 12: Alarm Control 12-5
3. Click on the drop-down arrow in the cell corresponding to the selected controller/door. The
following options will appear:
• Access Only – This is used when no Alarm Control panel is in use at that particular reader.
• Arm Only – Presentation of a valid card will arm the alarm. A reader in this mode would not
control access to a door nor disarm the alarm.
• Disarm Only – Presentation of a valid card will disarm the alarm. A reader in this mode would not
control access to a door nor arm the alarm.
• Arm/Disarm – Presentation of a valid card will toggle the state of the Alarm Panel. If the Alarm
Panel is armed, presentation of a valid card will disarm the alarm. If the Alarm Panel is disarmed,
presentation of a valid card will arm the alarm. A reader in this mode will not control access to a
door.
• Access/Disarm – Presentation of a valid card will disarm the alarm and grant access to the door.
• Access/Arm – Presentation of a valid card will grant access to the door while arming the alarm.
This option is not recommended because it has the potential to cause false alarms. However, it
is available as an option for special applications.
4. Click on the option pertaining to the selected controller/door.
5. Repeat steps 2 through 4 for each controller/door. The resulting window should look similar to
Figure 12-5 on page 5.
Figure 12-5: Setup System - Alarm Control Reader Type Set
2.2 Allow Access While Alarm System Offline
The Allow Access While Alarm System Offline column gives the operator the option to allow access
through a controlled door even when the master controller has lost communication with the alarm
control panel or, if the controller is a slave, with the master controller.
1. The default for the Allow Access column is set to .
2. To allow access while the alarm system is not in communication with the access control network,
locate the cell corresponding to the controller/door that is to allow access. Click
on the cell to toggle it to .
3. Once all the controllers/doors have been assigned an Alarm Control Reader Type and the Allow
Access columns have been set, click on the button. If the changes are not saved before
clicking any other button or exiting the System Setup window, the data entered is lost and must be
re-entered.
NOTE: In order for a User to have the ability to arm/disarm the alarm control system, they must be
set up to have access to the specific controller/door. For further instructions on how to give a User
access to a specific controller/door, see the Doors Users Guide - Section 4: Setup Users (P/N 01914-
100).