Specifications

Keri Systems, Inc. Doors
TM
Users Guide
01914-012 Rev. 5.5 Section 12: Alarm Control 12-3
1.0 Enable Alarm Control
1. To enable Alarm Control, click on the Setup ⇒ System pull-down menu or click the button
on the tool bar. Click on the System Options tab followed by the button.
The System Options window should look similar to Figure 12-1.
Figure 12-1: System Options Tab - Alarm Control Off
2. The default is for Alarm Control to be turned off.
3. Click in the check box beside the Alarm Control ON field. If a PXL-510 controller has not been
detected as the master controller, an error message appears (see Figure 12-2).
Figure 12-2: Alarm Control Enable Error
4. If a PXL-510 controller is set up as the master controller, perform an autoconfiguration (see
“Autoconfiguration” on page 32 in section 2). Once the autoconfiguration is complete, return to
click in the check box beside the Alarm Control ON field. If a PXL-510 was detected as the master
controller during the autoconfiguration, a check mark appears in the check box and the following
window appears (see Figure 12-3 on page 4).