Specifications

Doors

Users Guide Keri Systems, Inc.

10-6 Section 10: EntraGuard 01914-010 Rev. 5.4

2.0 Setup Dial Time Zones

Once an EntraGuard controller is in use, time zones have an additional use. A Dial Timezone must be

applied to the EntraGuard controller defining the hours a tenant will accept a call from visitors

requesting access through the EntraGuard unit. The process to set up a Dial Timezone is the same as

setting up any time zone (see “Setup Time Zones” on page 3 in section 3).

The difference is in where the time zone is applied.

• A time zone applied to the controller in the Dial Timezone column in the Setup System window

defines the daily hours when a tenant will accept calls from visitors using the EntraGuard unit.

• A time zone applied through an access group determines when a user is allowed entry through any

controlled door including an EntraGuard controlled door.

3.0 Setup Controllers/Doors

With the addition of an EntraGuard unit to the access control network, certain changes are made to the

databases to allow for specific EntraGuard configurations.

3.1 Controller Configuration

Columns are added to the Controller tab once the EntraGuard feature has been enabled. The following is

a list of those new columns.

Figure 10-4: Setup System Controllers Tab – Part 1

EG Connect Timer

The EG Connect Timer determines the length of connection between the EntraGuard unit and the

tenant’s telephone. Once the time set has been reached, the connection will cease. The time shown is in

seconds and may be set to anything between 30 - 255 seconds. The default is set to 60 seconds.

EG Output1 & EG Output2

Name – description of what the EG Output controls (i.e. Lobby Lights)

Timer – determines the amount of time in seconds the output is in effect (the default is set to 120)

Mode – determines what actions will activate an output

• Disabled - outputs are not disabled and not activated in any condition

• Tone Command - by a valid telephone command

• Access Granted - when a valid access request is granted

• Both Tone and Access - both a valid telephone command or a granted access request

TDD Enable

Not used at this time. Should remain in the OFF position.