Specifications

Keri Systems, Inc. Doors

Users Guide

01914-010 Rev. 5.4 Section 10: EntraGuard 10-5

1.3 Command Codes

Command codes are the telephone keys used to perform certain functions such as allow entry through

the EntraGuard controlled door, etc. See Figure 10-3 on page 4 of this section for their location in the

EntraGuard field.

Unlock Door 1

The number in this field determines the telephone key assigned to allow access through the EntraGuard

controlled door. The default for this field is 9.

Unlock Door 2

Although the default for this field is set at 8, this field is not used at this time.

Hang Up

The number in this field determines the telephone key assigned to disconnect from the EntraGuard

controller without granting access. The default for this field is 7.

Activate Output 1

The number in this field determines the telephone key assigned to activate output 1. This may be

something such as turning on lights, etc. The default for this field is 6.

Activate Output 2

The number in this field determines the telephone key assigned to activate output 2. The default for this

field is 5.

NOTE: It is possible to assign the same telephone key to all of these fields, but care should be taken to

make sure that all of these functions are needed at the same time.

1. To change the default values for any of these fields, click in the window you want to change. Delete

the number that is there and enter the number of your choice.

2. Click on the button to save these changes. If the EntraGuard parameters are not saved

before clicking any other button or exiting the System Setup window, the data entered is lost and

must be re-entered.

3. You must update the access control network with the new information. Click on the button

on the tool bar (for details on the update process refer to “Update the Network” on page 35 in

section 5).

1.4 Remote Commands

The Remote Commands option is for future use. The default is for Remote Commands to be disabled

(no check in the Remote Commands ON check box). Leave the box in its default state.