Specifications

Doors

Users Guide Keri Systems, Inc.

10-4 Section 10: EntraGuard 01914-010 Rev. 5.4

Figure 10-3: System Options Tab - EntraGuard Enabled

1.1 Select Enrollment Options

You must select the type of system the EntraGuard controller is connected to. Your selection in the

second field will affect the enrollment options you will have further in the setup process.

• Use Both Cards and EntraGuard IDs - Selecting this option will allow for both enrollment of cards

and User IDs in any combination. This is the default value.

• Only Use Cards - Selecting this option will limit enrollment to cards only (including the Card+PIN

option). If any users will need a User ID assigned to them, do not choose this option.

• Only Use EntraGuard IDs - Selecting this option will limit enrollment to User IDs only. If any users

will need a card assigned to them, do not choose this option.

1.2 Select Directory Code and User ID Digits

Directory Code Digits

The number shown in the Directory Code Digits box determines the number of digits in the code listed

in the EntraGuard directory. The directory code is the set of numbers used by visitors at the EntraGuard

controller to dial up the person they wish to contact. The tenant may then either grant or deny visitor

access to the building. The default for this field is 5.

User ID Digits

The number shown in the User ID Digits box determines the number of digits in the User ID assigned to

each user. A user enters their User ID to gain access through an EntraGuard controlled door. The default

for this field is 5.

NOTE: Great care should be taken when determining the digits in these fields. Once you have selected

directory codes and enrolled User IDs according to the selections you make here, you will not be able to

decrease the number of digits used. However, you will be allowed to increase the number of digits for

both of these categories. When the number of digits is increased additional zeros are added to the

beginning of previously enrolled users. These additional zeros must be used from that point on.