Specifications

Keri Systems, Inc. Doors
TM
Users Guide
01914-010 Rev. 5.4 Section 10: EntraGuard 10-3
1.0 Enable EntraGuard
If you have an EntraGuard controller connected to the access control system, the feature needs to be
enabled in Doors.
NOTE: The EntraGuard feature is automatically enabled if an EntraGuard unit is detected when an
autoconfiguration is performed on the system.
1. To manually enable the EntraGuard feature, click on the Setup ⇒ System pull-down menu or click
on the button on the tool bar, then click on the System Options tab. The System Options
window appears.
2. Click on the button. The System Options window will reveal the EntraGuard
field where EntraGuard options may be set (see Figure 10-1).
Figure 10-1: System Options Tab - EntraGuard Disabled
3. Click on the EntraGuard ON check box. A check mark appears in the box. Because the changes
required to implement the EntraGuard feature make major changes to the Doors program and its
supporting databases, a confirmation window appears (see Figure 10-2).
Figure 10-2: EntraGuard Option Changed - ON
4. Click on the button and the conversion to EntraGuard mode automatically occurs.
5. The EntraGuard fields change from grey to black letting you know it is available for editing of
specific EntraGuard options (see Figure 10-3 on page 4 of this section).