Specifications

Keri Systems, Inc. Doors

Users Guide

01914-009 Rev. 5.2 Section 9: Photo Badge Management 9-21

NOTE: Because of the variety of possible sources for photographs, specific information for creating the

photograph cannot be given here. Please refer to the documentation for that source device on how to

create the photograph.

5. Once the photograph has been created/located, the photograph is placed into the Image

Enhancement window where it can be edited to improve the quality of the image as it will be

printed on the badge (see Figure 9-23).

Figure 9-23: Image Enhancement

6. A variety of adjustments can be made to improve the quality of the photograph. At all times, a copy

of the original photograph is kept in the Original Image pane of the Image Enhancement window.

All adjustments are made to the photograph in the Preview Image pane of the Image Enhancement

window. The following adjustments can be made.

- Exposure – to brighten or darken the image.

- Contrast – to emphasize or de-emphasize the difference between light and dark portions of the

image.

- Red/Cyan Color Balance – to adjust the amount of Red/Cyan tint in the image.

- Green/Magenta Color Balance – to adjust the amount of Green/Magenta tint in the image.

- Blue/Yellow Color Balance – to adjust the amount of Blue/Yellow tint in the image.

Make these adjustments as necessary to improve the quality of the photograph image. If you

become dissatisfied with all the adjustments made, you can always return to the original image by

clicking on the button.

To view the entire photograph image, click on the Whole Image radio button. The entire image is

resized and displayed in both the Original and Preview image panes. To view the photograph image

in the perspective in which it will be printed, click on the One to One radio button. The image is

displayed in both the Original and Preview image panes in its original size, which may be either

smaller or larger than the pane size.

7. To exit the Image Enhancement window without making any changes, click on the

button. You can either start the Acquire Photo process all over again (return to Step 1 on page 20)

or exit the Badging Wizard entirely by clicking on the button again.