Specifications

Keri Systems, Inc. Doors
TM
Users Guide
01914-009 Rev. 5.2 Section 9: Photo Badge Management 9-15
4.0 Enable Badging in Doors
The enable badging parameter in the System Options allows an operator to enable the photo badge
management feature of the Doors program. Perform the following steps to enable the Photo ID Badging
feature.
1. Click the Setup ⇒ System pull-down menu or click the button on the tool bar. The Setup
System window appears (see Figure 9-14).
Figure 9-14: Setup System Window
2. Click the System Options tab. The System Options window appears (see Figure 9-15).
3. Click the button to bring up the badging field (see Figure 9-15).
Figure 9-15: System Options Tab – Badging Disabled
4. If your application does not use badging, verify there is not a check mark in the Badging ON box
inside the “Badging” field (see Figure 9-15 – this is the default value).