Specifications

Doors
TM
Users Guide Keri Systems, Inc.
8-8 Section 8: Multiple Sites 01914-008 Rev. 5.3
3.4 Site Personal Identification Number (PIN)
The site PIN field allows an operator to assign a “password” number to a site in the access control
network. Once a PIN has been assigned to a site, it is stored in the software and is visible each time you
open the Network Configuration tab. The PIN number is an extra security measure to prevent anyone
with the same software from gaining unauthorized access to any given site
1. Click on the “PIN” cell for the site. The default “PIN” is set at 0.
2. Type a four-digit number for the site. For example, the parts warehouse is assigned PIN 1111; type
1111 (see Figure 8-8 on page 9 of this section).
3.5 Site Phone Number or TCP/IP Address
If a site is configured for TCP/IP communications, the “Phone Number” column header changes to
“TCP/IP Address”.
3.5.1 Site Phone Number
The site phone number field allows an operator to assign the phone number for the modem at a site in
the access control network. This is the phone number that the host computer will dial to contact the site.
1. Click on the “Phone Number” cell for the site.
2. Type the phone number for the site. For example, the warehouse’s phone number is 555-4567; type
555-4567 (see Figure 8-8 on page 9 of this section).
3.5.2 TCP/IP Address
If you are using a TCP/IP Ethernet connection, you will need to enter the TCP/IP Address. The cell
heading will automatically change when you have selected the TCP/IP option in Setup System (see
“Ethernet TCP/IP Parameters” on page 5 in section 2).
1. Click on the “TCP/IP Address” cell for the site.
2. Type the address for the LAN-100 unit. The address must be entered in the standard “dot” notation
(e.g. 127.0.0.0).
3.6 Site Modem Initialization String or Remote Port Number
If a site is configured for TCP/IP communications, the “Modem Init” column header changes to
“Remote Port Number”.
3.6.1 Site Modem Initialization
The modem initialization field allows an operator to enter the initialization string for the modem at a
site in the access control network. The modem initialization string provides the best operating
parameters for the modem. As the modem initialization string differs per modem type and
manufacturer, refer to the modem’s manual for the initialization string.
1. Click on the “Modem Init” cell for the site.
2. Type the modem initialization string for the site’s modem.