Specifications

Keri Systems, Inc. Doors
TM
Users Guide
01914-006 Rev. 5.2 Section 6: System Operation 6-37
4.2.2 I/O Link Example
The following steps describe how to link an input point to an output point for window monitoring using
the example described in the I/O configuration section above. For this example, controller 3 is a PXL-
250 controller with an SB-293 Satellite board. This satellite board is configured for 2-door control.
Using dedicated I/O, one input is automatically configured for auxiliary RTE and one output is
automatically configured for door held open alarm annunciation. This leaves 5 inputs and 1 output that
can be programmed into I/O links.
1. To configure an input/output link, click on the Setup ⇒ System pull-down menu or click on the
button on the tool bar. Click on the Link Config tab.
2. Click on the Controller arrow and select the controller to be configured.
3. Click in the Link Name field and type in the name for the link. For this example type Window
Security (see Figure 6-38).
Figure 6-38: Select Controller and Enter I/O Link Name
4. Click on the Input 4 check box to select the Window Sensors input point (see Figure 6-39 on
page 38 of this section). Since this is a single input point, the Input Combination radio buttons do
not apply.
5. Click on the Output 4 check box to select the Window Alarm output point (see Figure 6-39 on
page 38 of this section).