Specifications

Keri Systems, Inc. Doors
TM
Users Guide
01914-006 Rev. 5.2 Section 6: System Operation 6-35
Link Name
To assign a descriptive name to a link:
1. Click in the “Link Name” field.
2. Type the name to be assigned to the link.
Option Board
The “Option Board” field displays the model number of the option board providing the input and output
points. This is an information field and is not editable.
Inputs
The “Inputs” check boxes allow an operator to select the inputs that should be assigned to the I/O link.
Inputs with grayed-out check boxes and without input point names are unavailable for assignment.
1. Click on the check box beside the input point name. A check mark appears indicating the input is
selected. Every click in the check box toggles between selecting and deselecting.
2. To deselect an input, click on the check box. The check mark disappears indicating the input is
deselected.
Input Point Name
The “Input Point Name” field displays the input point name assigned in the I/O Configuration section.
In this window, this field is not editable. To change an input point name, refer to “I/O Configuration” on
page 32 of this section.
Input Combinations
The “Input Combinations” radio buttons allow an operator to define what the state of the selected inputs
should be to generate an output. This is only valid if there are more than one input point being applied to
the I/O link.
1. If the Or radio button is selected, an input signal on the first input point or the second input point or
any of the input points will generate an output. Click on the Or radio button to select an Or input
combination.
2. If the And radio button is selected, an input signal must be received on the first input point and the
second input point and all of the input points at the same time to generate an output. Click on the
And radio button to select an And input combination.
Outputs
The “Outputs” check boxes allow an operator to select the outputs that should be assigned to the I/O
link. Outputs with grayed-out check boxes and no output point name are not available for assignment.
1. Click on the check box beside the output point name. A check mark appears indicating the output is
selected. Every click in the check box toggles between selecting and deselecting.
2. To deselect an output, click on the check box. The check mark disappears indicating the output is
deselected.
Output Point Name
The Output Point Name field displays the output point name assigned in the I/O Configuration section.
In this window, this field is not editable. To change an output point name, refer to “I/O Configuration”
on page 32 of this section.