Specifications

Doors
TM
Users Guide Keri Systems, Inc.
5-52 Section 5: Monitor and Update Controllers 01914-005 Rev. 5.9
4.2.1.4 Setup Destination
The Destination Window allows the operator to select the location for the backed up zip files. The
default is set for C:\kerisys\backup\archives.
Figure 5-57: Abakt Destination Window
NOTE: The Doors program is automatically closed when Abakt is started. Doors needs to be manually
started following any time Abakt has been opened.
4.2.2 Adjusting the Backup Directory
The door.abp file used by the backup program uses the default directory path of C:\Kerisys\DoorsX.XX\
for F1 Source and C:\Kerisys\backup\Archive for F4 Destination. F1 Source is where the files to be
backed up are located and F4 Destination is where to place the files selected for back up by F1. This
works as it is supposed to, unless the location of the Doors installation is changed. The door.abp file is
not changed or updated during the install process to reflect where Doors is installed. If Doors is
installed somewhere other than the default locations used in the install program, the following steps
must be taken:
1. Open the backup program, by clicking on the button.
2. Select the “F1 - Source” tab. Click on the button. This will remove the default directory
path.
3. Click on the button. Browse through the folders to find the location of the current Doors
installation. Select the folder and click on the button. The directory path location of the
Doors installation should now appear in the Directories window in the “F1 - Source” tab.
4. Select the “F4 - Destination” tab. Click on the button. Browse through the folders to find
the location of the “Kerisys\backup\Archive folder” installation. Select the folder and click on the
button.
5. Save the changes by clicking on File > Save Profile
NOTE: Steps 1 and 2 need to be done for when an upgrade to a newer version of Doors has been
installed.