Specifications

Keri Systems, Inc. Doors

Users Guide

01914-004 Rev. 5.2 Section 4: Setup Users 4-23

Internal Number

The internal number value is automatically entered when a card is enrolled. It is the card’s internal

identification number, read from the card when the card was presented to the enrollment reader. This

field cannot be edited.

Card Number

The card number refers to the number printed onto the body of the card (see Figure 4-25). The card

number is the second set of digits printed on the body of the card (in Figure 4-25, it is the digits

corresponding to 187491). The card number will be longer than 4 digits. For this example, the entire

number of this card is K1757 187491; the card number is 187491, 6 digits long.

Figure 4-25: Proximity Card Number

NOTE: The Card Number is an optional field. A card number is not automatically entered and is not

required for program operation.

Card+PIN

If you are using the P-650 Card+PIN Proximity Reader and Keypad, and have enabled the Card+PIN

option (see “Set Card+PIN (P-650) Mode” on page 22 in section 2), the card PIN (Personal

Identification Number) is automatically generated and assigned to a card during block enrollment. The

PIN cannot be changed or edited. The Card+PIN will not be visible if the operator has been assigned

Read Only rights for Setup Users (see “Setup Operators” on page 45 in section 2).

NOTE: Due to the algorithm used in generating a card PIN, it is possible for cards to have the same

PIN. Most card access systems allow for duplicate PINs associated with different cards. PIN

duplication does not compromise the security of the system.

Rollcall/Track

The Rollcall/Track cell selects a user to appear in the Rollcall/Track monitoring window (see “Set

Rollcall/Track” on page 20 in section 2). If you have enabled the Rollcall/Track option under Setup

System, the Rollcall/Track cell option default is ON during enrollment.

1. To inactivate Rollcall/Track, locate the On/Off cell. It should be .

2. Click on the cell; it changes to .

3. To activate Rollcall/Track, locate the On/Off cell. It should be .

4. Click on the cell; it changes to .

NOTE: The Rollcall/Track column does not appear unless you have enabled the Rollcall/Track

option (see “Set Rollcall/Track” on page 20 in section 2).