Specifications

Doors

Users Guide Keri Systems, Inc.

4-10 Section 4: Setup Users 01914-004 Rev. 5.2

1.2.2 Enrolling Wiegand Cards by Presentation

1. For enrollment of Wiegand cards by presenting to a reader, click on the . The

Enroll Cards window changes for Wiegand card presentation (see Figure 4-12).

Figure 4-12: Enroll Cards Window for Presenting Wiegand Cards to a Reader

2. On a Wiegand master controller, the “A” reader, “B” reader, or both readers may be used for

enrollment by presentation to a reader. In the “Channels” field, select which reader is to be used for

enrollment by clicking on the corresponding radio button.

3. In the “Primary Format” field, select the kind of reader being used by clicking on the corresponding

radio button.

4. Click on the button. If the Doors program is not connected to the access control

network, the program will automatically connect.

5. The reader’s LED blinks green slowly to indicate it is ready for enrolling cards.

NOTE: The reader/controller is not available for any other use during the card enrollment process –

any attempts to use a door associated with the master controller might disrupt the card enrollment

process and will be denied until card enrollment is complete.

6. Present the first card to the enrollment reader. The reader will beep to indicate the card was read

successfully and the card information will appear in the Enroll Cards window.

NOTE: If the Doors program is unable to enroll a card (because that card is faulty or has already been

enrolled), the reader will provide one long beep and an error message window is displayed providing a

brief description of the problem with the card being enrolled. Click the button to acknowledge

the error message; then correct the problem and continue card enrollment. If there is no

acknowledgement by the reader, after a card has been presented, the card may be of a format that is

incompatible with the reader.

7. Present the second card to the enrollment reader. Again the reader will beep.

8. Continue presenting cards until all have been enrolled. When completed, the card enrollment

window should look similar to Figure 4-13 on page 11 of this section.