Specifications

Doors
TM
Users Guide Keri Systems, Inc.
4-8 Section 4: Setup Users 01914-004 Rev. 5.2
1.2 Enrollment by Presenting to a Reader
Enrolling by presenting to a reader is best used when there are only a few cards to enroll or the cards are
not in sequential order. The cards must be on hand to be enrolled by presenting to a reader. The “A”
reader on a Proximity master controller is the enrollment reader. However, on a Wiegand master
controller, the “A” reader, “B” reader, or both readers may be used as the enrollment reader.
NOTE: If you are using the Card+PIN feature in connection with the P-650 Card+PIN Proximity
Reader and Keypad, you cannot enroll by presenting to a reader. Follow the instructions for block
enrollment in “Block Enrollment by Card Number Range” on page 3 of this section.
NOTE: If you are using a mixed PXL/EntraGuard system where users need to be given both a card and
a User ID, follow the instructions in “EntraGuard” on page 1 in section 10.
1. To enroll cards by presenting to a reader, click on the Setup ⇒ Users pull-down menu or click on
the tool bar button. These two icons are added to the tool bar and the Setup Users
spreadsheet window appears (see Figure 4-9). If the Setup Users spreadsheet window is not visible,
click on the tool bar button.
Figure 4-9: Setup Users Spreadsheet Window
2. Click on the button. If the Doors program is not connected to the access control network,
the program will automatically connect. The Enroll Cards window appears (see Figure 4-10).
Figure 4-10: Enroll Cards Window