Specifications

Keri Systems, Inc. Doors
TM
Users Guide
01914-004 Rev. 5.2 Section 4: Setup Users 4-3
1.0 Card Enrollment
Determine what kind of enrollment is needed for the access control system in use. For example, if you
have only PXL controllers being used, then you will need to enroll only cards (Card+PIN would be
needed if at least one of those controllers has a P-650 Card+PIN Proximity Reader and Keypad
connected to it). For enrollment of User IDs only, or cards and User IDs see “EntraGuard” on page 1 in
section 10. For enrollment of Temp User cards, see “Temp Users” on page 1 in section 13. For
enrollment of Dual Verification users, see “Dual Verification” on page 1 in section 14.
1.1 Block Enrollment by Card Number Range
Block enrollment by card number range is best used when there is a large quantity of sequential ID
numbered cards or credentials. This is true for Keri Systems Proximity Cards or for 26-bit Wiegand
formatted credentials (such as magnetic stripe, bar code, or keypad readers). Cards or credentials do not
have to be on hand when enrolled through the block enrollment by card number range process, but you
must have the facility code and they must have sequential ID numbers. For non-Keri Systems, Wiegand
formatted credentials, you must work with the manufacturer/supplier of the credentials to ensure that
the sequential ID number list you have for the credentials correctly reflects the ID numbers programmed
into the credentials.
Block enrollment by card number range is valid for “K” and “W” series Keri Proximity Cards
(identified by a “K” or “W” prefix on the number printed on the body of the card). Block enrollment by
card number range is not available for “C” series cards or key tags (used by older Keri Systems
products).
For proper block enrollment of non-Keri Systems Wiegand formatted credentials, the Wiegand reader
and the Wiegand credentials must transfer data in the 26-bit format defined in the Security Industry
Association’s Wiegand Interface Standard
(document number AC-01D-96) or in the Keri Systems
Reference Document Processing Wiegand Format Card Data
(P/N 01846-001). Proper enrollment
cannot be guaranteed if either the Wiegand reader or the Wiegand credentials do not transfer data in this
format.
NOTE: If you are using the Card+PIN feature in connection with the P-650 Card+PIN Proximity
Reader and Keypad, and PXL-250W/PXL-500W you must use 26-bit Wiegand cards enrolled through
block enrollment.
1. To enroll cards by block enrollment, click on the Setup Users pull-down menu or click on the
tool bar button. These two icons are added to the tool bar and the Setup Users
spreadsheet window appears (see Figure 4-1 on page 4 of this section). If the Setup Users
spreadsheet window is not visible, click on the tool bar button.