Specifications

Doors
TM
Users Guide Keri Systems, Inc.
3-46 Section 3: Database Programming 01914-003 Rev. 5.4
3. Click on the button. This will clear any information that may be stored in the access group
fields.
4. Click on the button and the Select Doors window appears (see Figure 3-32).
Figure 3-32: Select Doors Window - Available Doors
5. The Select Doors window in Figure 3-32 displays all doors recognized by the system. Click on the
doors to be included in this access group. For this example, click on the Back Door, Front Door,
and Manufacturing Door icons. The window should look similar to Figure 3-33. If an incorrect
door was selected, simply click on that door again. Each click on a door toggles its state between
selected and deselected.
NOTE: If a door has been configured as an elevator door by the Door Type command (see “Assign a
Door Type” on page 29 in section 3) its icon appears as . If a door has been configured as a gate by
the Door Type command (see “Assign a Door Type” on page 29 in section 3) its icon appears as .
The icon for an EntraGuard unit appears as .
Figure 3-33: Assigning Doors to the New Access Group