Specifications

Doors
TM
Users Guide Keri Systems, Inc.
3-38 Section 3: Database Programming 01914-003 Rev. 5.4
4.2.10 Door Forced and Door Held Alarm Outputs
The Door Forced and Door Held alarm outputs allow an operator to select the alarm annunciation mode
for door forced alarms and door held alarms.
A Door Forced alarm is activated whenever the door associated with the alarm output is forced open. A
Door Held Open alarm is activated whenever the door associated with the alarm output is held open
beyond the door open time period. When an alarm is activated it will remain on until the alarm
condition is corrected; a forced door must be closed and a door held open must be closed. Depending
upon the configuration of the controller, there are several options for configuring which alarms are
annunciated at which relays.
4.2.10.1 PXL Controller by Itself
PXL controllers have only one alarm output relay. All alarm outputs are annunciated through this relay.
The door forced alarm can be annunciated through the alarm relay or be disabled (a door forced alarm
will not be annunciated by the relay). The door held alarm can be annunciated through the alarm relay
or be disabled (a door held alarm will not be annunciated by the relay).
Door Forced Output
1. To set the door forced and door held alarm output values, click on the Setup ⇒ System pull-down
menu or click on the tool bar button. Then click on the Doors tab (see Figure 3-27 on
page 37 of this section). If the “Door Held Output” column does not appear in the window, use the
scroll bar at the bottom of the window and scroll to the right until this column appears.
2. Scan down the door name column and locate the door to have alarm output values assigned.
3. Locate the “Door Forced Output” column and click on the cell corresponding to the selected door.
4. Click on the arrow and a list of available alarm output values appears. Scroll through this list
and select the desired door forced output value. Alarm Out is the default value for this field.
Door Held Open Output
1. To set the door forced and door held alarm output values, click on the Setup ⇒ System pull-down
menu or click on the tool bar button. Then click on the Doors tab (see Figure 3-27 on
page 37 of this section). If the “Door Forced Output” column does not appear in the window, use
the scroll bar at the bottom of the window and scroll to the right until this column appears.
2. Scan down the door name column and locate the door to have alarm output values assigned.
3. Locate the “Door Held Output” column and click on the cell corresponding to the selected door.
4. Click on the arrow and a list of available alarm output values appears. Scroll through this list
and select the desired door held output value. Alarm Out is the default value for this field.