Specifications

Doors
TM
Users Guide Keri Systems, Inc.
3-26 Section 3: Database Programming 01914-003 Rev. 5.4
4.2 Door Configuration
Door configuration information is assigned under the Setup ⇒ System ⇒ Doors tab. The first time the
Doors tab is entered a Configure Dedicated I/O reminder window appears (see Figure 3-18). Refer to
“Configure Dedicated I/O Points” on page 17 of this section if you haven’t yet configured the dedicated
I/O points. Several door configuration options depend upon the values of the dedicated I/O points. Click
on the button to acknowledge the reminder window.
NOTE: When the alarm control feature has been enabled, additional columns appear for configuration
of the readers (see “Alarm Control” on page 1 in section 12).
Figure 3-18: Setup Dedicated I/O Points Reminder Window
4.2.1 Assign a Door Name
The door name parameter allows an operator to assign a descriptive name to a door on the access
control system. When monitoring system activity or reviewing event reports, it can be easier to follow a
string of events if the door associated with the events has a descriptive name.
NOTE: Door names must be 30 characters or less.
1. To assign a door name, click on the Setup ⇒ System pull-down menu or click on the tool bar
button. Then click on the Doors tab. The Setup Doors window appears (see Figure 3-19).
Figure 3-19: Setup Doors Tab - Part 1
2. Scan down the controller/door addresses column and locate a door to be named.
3. Click on the “Door Name” cell corresponding to the selected controller/door address.
4. Type a descriptive name for that door.
5. Scroll through the remaining doors available and give each a descriptive name. The resulting
window should look similar to Figure 3-20 on page 27 of this section.