Specifications
Doors
TM
Users Guide Keri Systems, Inc.
3-22 Section 3: Database Programming 01914-003 Rev. 5.4
4.1.1.1 Enable Controller Dial-Out
1. To set the controller dial-out parameters, click on the Setup ⇒ System pull-down menu or click on
the tool bar button. Then click on the Controllers tab. The Controllers window appears (see
Figure 3-14 on page 21 of this section).
2. Scan down the controller addresses column and locate a controller that should have permission to
connect to the host computer.
3. Scan across that controller’s row in the spreadsheet and locate the Dialout Enable button. If the
button is , controller dial-out is disabled.
4. To enable controller dialout, click on the Dialout Enable button. It will change to and the
text in the “Threshold Percent” column should change color from grey to black (see Figure 3-15).
When this text is black, the threshold percent value is editable.
Figure 3-15: Controller Dial-out Parameters – Enabled
5. Once changes have been made, click on the button. If the changes are not saved before
clicking any other button or exiting the system setup window, the data entered is lost and must be
re-entered.
6. Now update the access control network with the new information. Click on the button on
the tool bar (for details on the update process refer to “Update the Network” on page 35 in
section 5).
4.1.1.2 Set the Dial-Out Threshold Percentage
1. The default value for how full the controller’s event buffer should be before connecting to the host
computer is 80%. If this value should be changed, to 60% for example, click in the corresponding
“Threshold Percent” cell and type 60. Now, when the controller’s event buffer reaches 60% of full,
the controller will connect to the host computer and upload the contents of its event buffer.
2. Once changes have been made, click on the button. If the changes are not saved before
clicking any other button or exiting the system setup window, the data entered is lost and must be
re-entered.
3. Now update the access control network with the new information. Click on the button on
the tool bar (for details on the update process refer to “Update the Network” on page 35 in
section 5).