User`s manual

System Installation
RUBY-9719VG2AR User’s Manual 3-5
3.3 Installing the Single Board Computer
To install your RUBY-9719VG2AR into standard chassis or proprietary environment,
please perform the following:
Step 1 : Check all jumpers setting on proper position
Step 2 : Install and configure CPU and memory module on right position
Step 3 : Place RUBY-9719VG2AR into the dedicated position in the system
Step 4 : Attach cables to existing peripheral devices and secure it
WARNING
Please ensure that SBC is properly inserted and fixed by mechanism.
Note:
Please refer to section 3.3.1 to 3.3.5 to install INF/VGA/Ethernet/Audio drivers.
3.3.1 Chipset Component Driver
The chipset on RUBY-9719VG2AR is a new chipset that a few old operating systems
might not be able to recognize. To overcome this compatibility issue, for Windows
Operating Systems such as Windows XP, please install its INF before any of other
Drivers are installed. You can select the Intel Chipset driver from the RUBY-
9719VG2AR CD-title.
3.3.2 Intel Integrated Graphics GMCH Chip
RUBY-9719VG2AR comes with the Intel
®
GMA X4500 graphics supporting DVMT
5.0 display memory up to 287 MB. Shared 32 accompany it to 128MB system
Memory with Total Graphics Memory. This combination makes RUBY-9719VG2AR
an excellent piece of multimedia hardware.
With no additional video adaptor, this onboard video will usually be the system
display output. By adjusting the BIOS setting to disable on-board VGA, an add-on
PCI-Express by 16 VGA card can take over the system display.
Drivers Support
Please select Intel Graphic driver from the RUBY-9719VG2AR Driver CD-title.
Driver supports Windows XP.