Installation Guide

Notices

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate this equipment.

• Installation and maintenance service shall only be performed by qualified technicians.

• This unit is intended to be supplied by an UL Listed PoE (Power over Ethernet) power

source/device suitable for use at Tma 50°C whose output meets LPS (or PS2) and

output is rated: POE DC 37-57 V, 0.35-0.22 A or DC 12V, 1.0 A.

• All cable glands should be properly assembled and protected.

• If using flexible conduit, ensure that no cable is exposed.

• If using plastic corrugated tubing, ensure that the material has F1 level compliance

certified by UL.

• This product does not include flexible steel conduits. If using flexible metal conduits,

use stainless steel, an aluminum alloy or metal composed with rust protection

certified by UL.

• The camera is only to be connected to PoE networks without routing to outside

plants. For non-PoE installations: only use 12V 1A VDC power supplies certified by

Alarm.com for this camera model. Contact Alarm.com for more information.

Drill template

PERFORATION (DO NOT PRINT)