080p Indoor Wi-Fi Camera Quick Start Guide ADC-V523
Pre-installation checklist • ADC-V523 camera (included). • AC power adapter (included). • Wireless (2.4 or 5 GHz) connection to broadband (Cable, DSL, or Fiber Optic) internet. • A computer, tablet, or smartphone with Wi-Fi is required if the router does not have the Wi-Fi Protected Setup (WPS) feature. There are three options for connecting the ADC-V523 to the Internet: Access Point (AP) mode, Wi-Fi Protected Setup (WPS) mode, and Ethernet mode.
• • • • • In the box Installation V523 camera Mounting plate Power supply User guide Wall anchors & screws (x2) Connect the camera to the Wi-Fi network AP mode To ensure sufficient Wi-Fi signal, complete these steps with the camera near its final location but prior to mounting. Overview 1. Connect the camera’s AC power adapter and plug it into a non-switched outlet. 2. The camera’s LED will begin to flash white.
LED reference guide 4. 5. 6. •Off Power off •Solid green Connected to Alarm.com Select the camera from the video device list or type in its MAC address to begin adding the camera. The camera’s MAC address is located on the bottom of the camera or on the packaging. •••• Flashing green Local network connection Follow the on-screen instructions to finish adding the camera. •••• Flashing green+red Camera resetting to factory default You may configure camera settings from the Customer Website.
Notices Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
8281 Greensboro Drive Suite 100 Tysons, VA 22102 © 2019 Alarm.com. All rights reserved. Designed in the USA. Made in China.
