Product Manual

Temperature Sensor
Product Manual
Installation
For optimal performance install the Temperature
Sensor approximately 5 feet above the oor of
an interior wall. Avoid installing the Temperature
Sensor on an exterior wall, in areas that are close
to heating or cooling vents, and areas that are
exposed to direct sunlight. The Temperature Sensor
is designed for indoor use only.
1. Remove the battery tab from the
Temperature Sensor.
2. Mount the Temperature Sensor on the wall
using the nail or double-sided adhesive
tape provided.
Adding the Temperature Sensor to the Network
To add the Temperature Sensor, rst install the panel and
place all other Z-Wave devices in their nal locations.
Next put the panel into Add Mode. You can do this by
completing the following steps:
1. If installing other Z-Wave devices, make sure
to install and add them to the network rst.
After you have added all other Z-Wave devices
to the network:
i. Run a Network Rediscovery.
ii. Verify that the Link Quality for all devices is good.
2. Ensure the panel and the Remote Temperature
Sensors are in their nal locations.
3. Navigate to the Equipment List page on the Dealer
Website or in MobileTech.
4. Select emPower Management.
5. Select Add Z-Wave Devices.
6. Wait for the bolded message “Checking for new
devices on the network.”
Once the panel is in Add Mode, press the Pairing
button on the Temperature Sensor to add it to
the Z-Wave network. You will see the light on the
Temperature Sensor turn solid white when it has
been successfully added, and you also will see the
device appear on MobileTech.
pairing button
Box Contents:
Temperature Sensor
CR123 Battery
Nail
Double-sided Adhesive Tape