Operator`s manual

OPERATION

EM 1700,2200,2200F,2500 04/09 Operation Section 4-11

OPERATION

2. Shank Depth

a. The shanks are designed to operate at 8-16 “ deep. See diagram for depth settings. Please note

thatthe settings are approximate depending on your field conditions. Be sure to verify the shank

depth in thefield with some measuring device.

b. To make adjustments

(1) Make sure the unit is fully raised and all transport locks are properly installed.

(2) Remove the depth setting pin from both sides of the mainframe and reinstall them in thede-

sired hole referencing the depth setting decal on each side of the mainframe to ensure thatthe

pins are in the same setting on both sides of the machine.