Operator`s manual

OPERATION

EM 1700,2200,2200F,2500 04/09 Operation Section 4-10

OPERATION

8. SETTING THE IMPLEMENT

8.1 Setting the Tillage Equipment

1. Disc Gang Angle

a. The Disc Gang angle can be varied from 3° to 18° in 3° increments. The lower settings will leave

largeramounts of residue on the surface while the higher settings will bury and mix more soil with

the residue.

b. To make adjustments:(1) Remove the lynch pin from the disc angle pin and remove the pin.(2)

Slide the disc gang tube forward or rearward until the Slide block aligns with the correct hole.Slid-

ing the front and rear gang tube away from each other increases the angle aggressiveness ofthe

disc gangs.