Operator`s manual

ASSEMBLY

EM 1700,2200,2200F,2500 04/09 Assembly Section 3-29

ASSEMBLY

INSTALLING LIGHT KIT UPRIGHTS AND LIGHTS

NOTE: It may be easier to assemble light uprights using a bench vise before installing light assembly to mount-

ing brackets on machine.

1. Install reflector plate to upright using two (2) 3/8” X 1 ¼” bolt (00753642) and retain with 3/8” lock nut

(00015800).

2. Install red reflector decal to the top of reflector plate and orange reflector to bottom of reflector plate so that

both are facing the rear of machine.

3. Install light to upright using 3/8” bolt (00011400) and retain with 3/8” locknut (00015800).

4. Install each light kit upright assembly to each mounting brackets using three (3) 3/8” x 1 ¼” bolt

(00753642)and retain with 3/8” locknut (00015800).

NOTE: 1700 and 2200 outer mounting brackets are located on the outer edge of the v-ripper frame.

NOTE: Light mount strap (12) is only used if coil tine is not attached.

5. Install wiring harness wishbone (00726963) to SMV sign mount using bolt (3263N6C) and retain with

locknut(329023C).

6. Run wiring harnesses to each side of machine indicated on each wire through the hose retainers on rear

mainframe to center (or red light standards) and connect harness connections to the light.

INSTALL SMV SIGN MOUNT

1. Install SMV sign mount (2460307) to rear mainframe using 3/8” x 1 ¼” bolt (00753642) and retain with 3/8”

locknut (00015800).