Operator`s manual

ASSEMBLY

EM 1700,2200,2200F,2500 04/09 Assembly Section 3-27

ASSEMBLY

INSTALLING COIL TINE LEVELER (1700)

1. Attach inner cross tube(1) to coil tine assemblies and retain with 5/8” x 1 1/2” bolts (6) and 5/8” lock nut (7).

Note: Coil tine angle is set by which bolt hole you select. (See diagram 3-26)

2. Lift coil tine assembly to end of Wdmt short mount tubes and retain with U blots (3) and 5/8” locknut (7).

Two U-bolts will be used per mount tube.

Note: For proper spacing there should be 10" between rear middle tines.

3. Attach adjustment bar (5) to coil tine adjustment plates and secure with 1/2” x 1 1/2” bolts (8) and ½”

locknuts(2).

Note: only lightly tighten bolts so adjustment will be easier.

4. Secure adjustment bar (5) with pull pin (4) and hair clip pin.

Note: Coil tine pressure will be set by which pin hole you select.