Operator`s manual

ASSEMBLY

EM 1700,2200,2200F,2500 04/09 Assembly Section 3-13

ASSEMBLY

RUN COIL TINE HYDRAULIC HOSES (2200F or 2500)

NOTE: While running hydraulic hoses it may be helpful to lay out all hoses to each location before installing. It

may also be helpful after laying out hoses to remove the color markings from each end of one hose in each set

of two.This will be helpful when connecting hoses to cylinders and fittings for proper function. Example: Hoses

with markings to base end of cylinder and hoses with no markings to rod end of cylinder.

1. Start by running red tagged hoses up through retaining rings on the left hand side of the tongue

2. Then run red hoses through left mainframe tube. (Run hoses through black Kevlar sleeve provided and ty-

rap to hold in place. Kevlar sleeve should be attached to hoses where hoses pass through hole in

mainframe to prevent premature hose wear.)Note: Use of an electric wire fish may be needed to tie hoses

to and then pull through.

3. Install tee fittings (00726792) to red hoses.

4. Install yellow hoses to both ports of one tee fitting. Run hoses through hose retainer in V-ripper frame, then

down through the outer coil tine tubes and connect to the retract side of both coil tine cylinders.

5. Install green tagged hoses to both ports of the tee fitting and down through outer coil tine tubes and

connect to extend side of both coil tine cylinders.

6. Check all fittings to make sure all connections are on tight.

7. Cycle system multiple times to remove all air from lines to insure proper function of sequence valve.