Operator`s manual

ASSEMBLY

EM 1700,2200,2200F,2500 04/09 Assembly Section 3-9

ASSEMBLY

Disc Wing Cylinder (2467105) 3 ½” X 10

1. Remove cylinder pins from cylinder discard pin from rod end of cylinder, it will be replaced with a different

pin in a later step.

2. Remove shipping plugs from cylinder hydraulic ports

3. Insert 90º elbow fitting (1937156) into cylinder ports

4. Connect hydraulic cylinder base to inner disc wing frame by reusing cylinder pin provided with cylinder.

5. Secure pin with cotter pins6.Check to make sure clevis on rod end is screwed all the way down to insure

proper wing travel.

6. NOTE: Over extension of linkage may result in tearing out hinge lugs on disc wing.

7. Install disc wing lifting links, one left and right per side of machine LH (1) RH (2) to the inner disc wing with

pin (5) and retain with 1 1/4” flat washer and cotter pin 3/16” X 2" (12)

8. Install center lifting link to the outer disc wing with pin (7) and retain with 1 1/4” flat washer and cotter pin 3/

16” X 2" (12)

9. Extend cylinder rod

10. 10.Connect LH, RH, Center lifting links and rod end of cylinder together with pin (6) and retain with 1"

washer(11) and cotter pin 3/16” X 2" (12)