Operator`s manual
ASSEMBLY
EM 1700,2200,2200F,2500 04/09 Assembly Section 3-2
© 2009 Alamo Group Inc.
ASSEMBLY
TRACTOR PREPARATION
Have a tractor with sufficient horsepower and traction. Soil type, soil moisture, type of crop, depth of opera-
tion,etc. will determine horsepower and traction requirements. Normally, 25 to 35 horsepower per shank isre-
quired. Have your tractor adequately equipped to operate at speeds of 4-1/2 MPH to 6 MPH as this speedwill
provide the best results.
All personnel should wear hard hats, safety shoes, safety glasses, and proper hearing pro-
tection at all times during the assembly process for protection from injury.
The components of this implement are very heavy. Securely lift the components using
appropriate and adequate lifting devices. Block all components up securely before working
or reaching under components.
Use extreme caution when getting onto the Implement to perform assembly procedures or
maintenance. Only stand on solid flat surfaces to ensure good footing. Use a ladder or
raised stand to access high spots which cannot be reached from ground level. Slipping and
falling can cause serious injury or death.
Use genuine M&W parts and fasteners. These parts are made and tested to M&W specifica-
tions. Non-genuine “will fit” parts do not consistently meet these specifications. The use of
“will fit” parts may reduce the implements performance, void warranties, and present a
safety hazard.
READ, UNDERSTAND, and FOLLOW
the following Safety Messages. Serious injury or
death may occur unless care is taken to follow the warnings and instructions stated in the
Safety Messages. Always use good common sense to avoid hazards.
(SG-2)
Al
ways rea
d
care
f
u
ll
y an
d
comp
l
y
f
u
ll
y w
ith
th
e manu
f
ac
t
urer
’
s
i
ns
t
ruc-
tions when handling oil, solvents, cleansers, and any other chemical
agent.
(SG-22)
Never work under the Implement, the framework, or any lifted compo-
nent unless the Implement is securely supported or blocked up to pre-
vent sudden or inadvertent falling which could cause serious injury or
even death.
(SG-14)
U
se cau
ti
on an
d
wear pro
t
ec
ti
ve g
l
oves w
h
en
h
an
dli
ng s
h
arp o
bj
ec
t
s suc
h
as
bl
a
d
es,
knives, and other cutting edges. Be alert to worn component surfaces which have sharp
edges. Sharp surfaces can inflict severe laceration injuries if proper hand protection is not
worn.
(SG-37)