Installation guide

A-4 Alacritech Accelerator Hardware Installation Guide (Copper)
FCC COMPLIANCE STATEMENT
We, Alacritech Inc., at
234 E. Gish Road
San Jose, CA 95112
[phone]
declare under our sole responsibility that the product(s):
Alacritech SLIC P/N’s 100000, 100001, 100004, 100005, 100007, 100009,
SEN1001T, SEN1001F, SES1001T, SES1001F, SEA1001T, SEA1001F,
SEN2002XT, SEN2002XF, SEN2001XT, SEN2001XF, SES2002XT,
SES2002XF, SES2001XT, SES2001XF, SEA2002XT, SEA2002XF,
SEA2001XT, SEA2001XF, SEN2104ET, SEN2104EF, SEN2102ET,
SEN2102EF, SES2104ET, SES2104EF, SES2102ET, SES2102EF.
Comply with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device. The device must however be listed as a Class
A device because the support equipment used during the testing of the
product did not have an FCC DoC. As such, the following FCC statement
applies:
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own
expense.
The user may find the following booklet prepared by the Federal
Communications Commission helpful:
The Interference Handbook
This booklet is available from the U.S. Government Printing Office,
Washington, D.C. 20402. Stock No. 004-000-00345-4.
NOTE: In order to maintain compliance with the limits of a Class B digital
device, Alacritech requires that you use network cables of a specific